relay - How to command a 220v device through a 12v output - Electrical Engineering Stack Exchange

I have a vending control board whose output is 12v-DC but the problem is that with this device I have to control a device whose input is 220V-AC. Can anybody help me make this possible? Sorry for m

Electrical Engineering Questions, PDF, Transformer

troubleshooting - Relay system not always working - Electrical Engineering Stack Exchange

Wiring a relay for mains power - Electrical Engineering Stack Exchange

pcb - Variable output LM317 power supply circuit - potentiometer burning - Electrical Engineering Stack Exchange

12v Relay to 240v Connection - General Electronics - Arduino Forum

voltage regulator - Where am I going wrong with LM317 power supply circuit? - Electrical Engineering Stack Exchange

Battery Charger Cut off - Electrical Engineering Stack Exchange

VPI Operation, Installation, and Maintenance - Alstom

relay - How to feed a 12V DC timer circuit from 220V AC power lines? - Electrical Engineering Stack Exchange

optoelectronics - How to connect 111ager Solid State Relay with Arduino to control a 5VDC@2.1A load - Electrical Engineering Stack Exchange

voltage regulator - Can I use an L7805CV with an AC input? - Electrical Engineering Stack Exchange

signal - Sending digital sensor ouput over cable upto 30meters - Electrical Engineering Stack Exchange

arduino - Triac based switching with reverse voltage protection - Electrical Engineering Stack Exchange