LED strip dim and MOSFET very hot when powered through Arduino - Project Guidance - Arduino Forum
4.7 (451) · € 14.99 · In Magazzino
Hi, I have been using the following setup to power and control 12V led strip through my Arduino Uno R3: Everything was fine when I used a short strip, but now I wanted to try and control a bit longer (5m = 14.4W/m) 2 pin led strip. When I connect everything up and power on (12V, 5A source), the led strip is noticeably dimmer than it would be powered straight from the source. It's got red and blue lights mixed and there is no clear pattern, but a few leds in a row would be brighter, then like
RGB LED strip MySensors Forum
Transistor Work but Very HOT - LEDs and Multiplexing - Arduino Forum
Issue with LED Strip Brightness using Arduino Mega and N-Channel MOSFETs - Electrical Engineering Stack Exchange
LED strip dim and MOSFET very hot when powered through Arduino - Project Guidance - Arduino Forum
Reviving a Makerbot Replicator 2X
Burnout / overheat question - Project Guidance - Arduino Forum
RGB LED strip MySensors Forum
I have troubles understanding the consumption of a single ws2813 5m stripe. - FastLED Archive - Maker Forums
Motherboard RGB header smoked using RGB strip.
Arduino-controlled RGB LED Infinity Mirror : 13 Steps (with Pictures) - Instructables
Dimming a LED Strip with a MOSFET (ESP8266) - LEDs and Multiplexing - Arduino Forum
Dimming an LED strip - LEDs and Multiplexing - Arduino Forum
LED Strips with MOSFET Will This Work? - Project Guidance - Arduino Forum
Arduino-controlled RGB LED Infinity Mirror : 13 Steps (with Pictures) - Instructables
MOSFET Switch behaves strange - Project Guidance - Arduino Forum