Trouble with 12V Relay attached to Pump - Arduino MEGA2560 - Project Guidance - Arduino Forum

I have attached to my Arduino a 2 Channel 12V Relay. Currently the red light on the Relay is working as my program switches LOW and HIGH every 5 seconds, so I know it's communicating. My 12VDC/AC power supply is plugged in the + is spliced in through the orange wire connected to the COM2. On the NO2 I have the +(pos) going to the pump. The -(neg) of the pump is connected to the power supplies -(neg). For some reason I get no response from the NO2 switching on or off. When the red light on the

40 Awesome Arduino Projects That You Must Try 2023: Get Started with DIY Electronics and Programmable Circuits! - Latest Open Tech From Seeed

How To Control a DC Motor with an Arduino - Projects

Arduino - Controls Pump

Can an Arduino use a 12 V relay? - Electrical Engineering Stack Exchange

Relay freezes arduino - Project Guidance - Arduino Forum

Is it possible to build a timer switch based on Arduino to control the ON/OFF cycles of a 1HP pump? - Quora

Can an Arduino use a 12 V relay? - Electrical Engineering Stack Exchange

How to use 12VDC Relay Module with Arduino

Guide for Relay Module with Arduino

DIY: Relay Switch Motor Controller - Arduino : 4 Steps (with Pictures) - Instructables

DC Motor Direction Control using Arduino - The Engineering Projects

Blynking an IoT Yunshan ESP8266 250V 10A AC/DC WIFI Network Relay Module